Accelerated Curing Tank

Accelerated Curing Tank

•    This curing tank has been designed to accommodate 150mm / 70.6mm cube moulds and upto 36/72 cube mould can be cured in one go.
•    Controlled 35° C or 100° C ± 2° C Curing Temperature for concrete.
•    Controlled 27° C ± 2° C Curing Temperature for grey cement.
•    The pump, drain valves and electrical equipment are housed in a compartment located at one end of the tank.
•    The tank is heated by an immersion heater under normal conditions and refrigeration system for grey cement the temperature is controlled at 35° C or 100° C ± 2° C / 27° C +2° C,expect for the 15 minutes after immersion of the freshly made specimens.
•    This special curing tanks have been designed for hot water curing or steam curing in accelerated strength concrete.
•    The interior is made from stainless steel.
•    The tank is fully insulated, comes complete with a hinged lid, heater, thermostat and re-circulated pump.
•    Provision of two removable racks allows free circulation of water around each mould.
•    24 Hour cycle from time of mixing.
•    The electronic programmer can control up to four test cycles with different thermal gradients and curing time to a defined temperature value for a complete automatic curing cycle.
•    The control panel include a 28 column thermal printer.
•    6/12 moulds of 150 mm / 70.6 mm size
•    12/24 moulds of 150 mm / 70.6 mm size
•    24/48 moulds of 150 mm / 70.6 mm size
•    36/72 moulds of 150 mm / 70.6 mm size

Accelerated Curing Tank ALTEC Laboratory Equipments and ALTEC Laboratory Instruments Tenders.